eldo_user

Running Eldo
Simulation Connection Manager
Table 2-1. Simulation Connection Manager Arguments (cont.)
Argument
Description
disconnect [ | all]
kill [ | all]
.plot / .probe
load
quit | exit
clear
3. You can select the remote simulation, connect to it and enter the required .PLOT or
.PROBE commands with the usual Eldo syntax, for example:
$ eldo -connect
$ command> connect
$ command> .plot tran V()
$ command> exit
Close the communication channel with remote
simulation and resume the simulation. This
command only applies to connections in active/
opened state.
If is not specified, the command is sent to
the active simulation.
If ALL is specified, the command is sent to all
remote simulations with an open or active
communication channel.
Terminate the remote simulation causing the
simulation to end prematurely. This command
only applies to connections in active/opened state.
If is not specified, the command is sent to
the active simulator.
If ALL is specified, the command is sent to all
remote simulations with an open or active
communication channel.
Add a .PLOT or .PROBE command to the active
simulation.
Load the content of the specified file and send
each command to the active simulation.
Commands are filtered to send only those
supported (.PLOT/.PROBE) by the simulator.
Exit the simulation connection manager.
Reset the output transcript.
4. To disable remote access to a simulation specify -noconnect.
Note
The interactive exchange is only for outputs, not for inputs. It is not possible to force
signals during simulation with -connect.
Eldo® User's Manual, 15.3 49