eldo_user

Analyzing Simulation Results
Marching Update
3. In the General options page, go to the Marching Waveforms area and set the update
interval by either of the following options:
Automatically Update Displayed Waveforms Every X time interval: The time
interval can be by second, minute, or hour.
Automatically Update Displayed Waveforms Every X% of Simulation: This updates
based on the percentage completion of the simulation.
Be careful not to set too small of an interval. Setting a short interval increase the number
of updates and then the amount of resources globally used to update the waveform data
viewed in EZwave.
Note
The following limitation applies for this scenario:
If jwdb_servermode is set (from command line or in the eldo.ini file) when an Eldo
simulation is invoked, the simulation output data cannot be accessed until after the
simulation completes.
Related Topics
Tip
See the EZwave User’s and Reference Manual.
EZwave Joint Waveform Database (JWDB)
Displaying Eldo Simulation Data in EZwave
376
Eldo® User's Manual, 15.3