eldo_user

Analyzing Simulation Results
Marching Update
Output in JWDB format: Invoke the Eldo simulator and run a complete simulation as
in the following example:
eldo test.cir &
Then invoke EZwave and use the File > Open option to open the .wdb file generated by
the simulation.
2. To update the data in the EZwave viewer, click the Update Waveform Data button in the
EZwave toolbar. This updates displayed waveforms with new simulation data.
Note
For this release, the following limitation applies for this scenario:
If jwdb_servermode is set (from the command line or in the eldo.ini file) when an
Eldo simulation is invoked, the simulation output data cannot be accessed until after the
simulation completes.
Related Topics
Tip
See the EZwave User’s and Reference Manual.
EZwave Joint Waveform Database (JWDB)
Displaying Eldo Simulation Data in EZwave
Marching Update
Waveform data can be collected from a running simulation at a predefined set interval. This
interval is set in EZwave and is run simultaneously with the Eldo simulator. This automates the
process of updating waveform data viewed in EZwave.
Procedure
1. Invoke Eldo simulator using one of the following methods:
Command line invocation: Invoke with EZwave with the following command:
eldo test.cir -ezwave &
Output in JWDB format: Invoke the Eldo simulator and run a complete simulation as
in the following example:
eldo test.cir &
Then invoke EZwave and use the File > Open option to open the .wdb file generated by
the simulation.
2. In EZwave, select Edit > Options to invoke the EZwave Display Preferences dialog
box. Select General from the list in the dialog box to open the General options page.
Eldo® User's Manual, 15.3 375