eldo_user

Setting Up An Analysis
Transient Noise Analysis
The plot of the VCO control node is shown in Figure 6-18 and Figure 6-19 (green
curves). The plot of the PLL output will be used to compute the phase noise spectrum.
Figure 6-19. VCO Control Node - Restarted Transient Noise Analysis
3. The Waveform Calculator in EZwave is used to compute the Phase Noise spectrum
from the transient noise analysis results. The post-processing function
noisetrantophasenoise() (located in the RF functions menu) is applied on the VCO
output waveform V(VCO_OUT) between 6μs and 100μs.
262
Eldo® User's Manual, 15.3