eldo_user

Eldo Interactive Mode
Controlling Execution
Note
This SETBUS syntax is different to the Eldo .SETBUS syntax used in the netlist .cir file.
See .SETBUS and .SIGBUS in the Eldo Reference Manual. However, if you want to use the
netlist syntax in interactive mode, specify the Eldo interactive command:eldo>LSIM OFF
TRANSITION
TRANSITION TT VALUE [DELAY]
TT
VALUE
DELAY
Transition Time
Value of the signal after the transition
Time delay before the transition starts
Overwrite the signal which was on node by a PWL:
Vxx 0 PWL (
)
Controlling Execution
This section describes the commands used to control execution.
LOAD
This command stops the current simulation, and Eldo loads the file . Extension .cir
is assumed.
SAVESIM
Eldo creates three files:
1. filename.eilThis file contains all the commands typed since the loading of the circuit
file; it is possible to re-execute this set of functions by:
-i circuit -eil filename.eil
2. filename.chiThis file contains the ASCII output.
3. filename.couThis file is the binary output file readable by graphic-postprocessors.
Note
A .pz file might be created if a .pz card exists.
The files circuit.cou and circuit.chi are then reset.
1466
Eldo® User's Manual, 15.3