eldo_user

Warning
Number
Table A-16. Miscellaneous Warnings (cont.)
Description
Error and Warning Messages
Miscellaneous Warnings
Warning 1471 COMMAND .PARAMDEX %s: It is not possible to define the settings of a
parameter as a fraction of the range value (using the RNG argument) when
this parameter has a non-uniform distribution
Warning 1472 EXTRACT MODE: %s command has been detected in the netlist. This
command is ignored. This can cause unexpected results if some extracts use
the swept parameter(s)
Warning 1473 COMMAND .PROBE %s: The default analysis for .SST results is set to
FSST. If TSST results are required, the type of analysis must be explicitly
given
Warning 1474 COMMAND .PROBE %s: The default analysis for .MODSST results is set to
FMODSST. If TMODSST results are required, the type of analysis must be
explicitly given
Warning 1475 More than %ld points are required for %s analysis. Output database might be
very large
Warning 1476 License message from Provider: %s -- Feature: %s
Warning 1477 COMMAND .PARAMDEX: wildcards in parameter %s are not allowed.
This definition is ignored
Warning 1478 The initial value of parameter %s set for optimization is ignored because this
parameter is used in a STEP command
Warning 1479 Some %s commands are declared for %s analysis. They are ignored because
this analysis is not enabled
Warning 1480 COMMAND .SETSOA: Model %s not found in subckt %s
Warning 1481 COMMAND .SETSOA: Subckt %s not found: command ignored. If you
specified an instance name instead of a subckt name try with keyword "inst="
instead of "subckt="
Warning 1482 COMMAND .PLOT: complex waveforms can not be plotted using
(VERSUS) keyword. They will be represented using their magnitude
Warning 1483 COMMAND .DEX: the analysis is disabled because there must be at least 2
factors
Warning 1484 AC analysis will not be performed during transient because of the commands
ordering: AC command must appear before .TRAN for that
Warning 1485 COMMAND .PARAMDEX: %s is ignored. It defines a DEV-like variation
while the model parameter has LOT specifications
Warning 1486 COMMAND .PARAMDEX: %s is ignored. It defines a LOT-like variation
while the model parameter has DEV specifications
Eldo® User's Manual, 15.3 1443