eldo_user

Warning
Number
Table A-16. Miscellaneous Warnings (cont.)
Description
Error and Warning Messages
Miscellaneous Warnings
Warning 1433 COMMAND "%s": This command is interpreted as .PROBE
Warning 1434 COMMAND "%s": Analysis disabled. MODEL %s is crypted. Accessing its
parameters is not possible unless:
1/ command .SETKEY is crypted with the .MODEL
2/ command .USEKEY must be given in the netlist using the encrypted
models
Warning 1435 New definition of .FOUR %s ignored
Warning 1436 COMMAND ".USE_VERILOG": This command has been deprecated inside
Questa ADMS. ai file is ignored and the work library loaded instead
Warning 1437 COMMAND "%s": Quantity %s has been replaced by %s
Warning 1438 COMMAND .EXTRACT/.MEAS %s: Unable to find measurement %s.
Command ignored
Warning 1439 Parameter %s found in %s %s depends directly or undirectly on DEV
specification. This is not supported yet by Questa ADMS
Warning 1440 .OPTION %s: unknown specification %s ignored
Warning 1441 .OPTION %s is ignored. It is only active when PSF_VERSION=2
Warning 1442 COMMAND "%s": The type of analysis must be specified when RF analysis
are used. Command ignored
Warning 1443 COMMAND "%s": Unable to code %s in base %ld
Warning 1444 COMMAND "%s": labeled "%s". The expression "%s" contains a SNF card
that was not found
Warning 1445 COMMAND .OPTIMIZE: OUTER specification is ignored since the netlist
contains no .STEP commands
Warning 1446 COMMAND .EXTRACT/.MEAS %s: Fitting waveforms requires to have
either .option OUT_STEP, TIMESMP or FREQSMP. Fitting command
ignored
Warning 1447 Unable to release %s license, feature "%s"
Warning 1448 COMMAND "%s": No .extract or .meas labeled %s was found. This
command is ignored
Warning 1449 COMMAND .FILTER: keyword %s has already been defined. First value is
kept
Warning 1450 OBJECT "%s": W/L parameters specified, a model should have been
assigned to this device. As a value has been set, these parameters are ignored
for computation of the effective resistor value
Eldo® User's Manual, 15.3 1441