eldo_user

Warning
Number
Table A-16. Miscellaneous Warnings (cont.)
Description
Error and Warning Messages
Miscellaneous Warnings
Warning 1093 COMMAND .LIMIT: complex output is not allowed inside name. Statement
ignored.
Warning 1094 COMMAND .MEAS: duplicate measurement name name
Warning 1095 COMMAND .MODEL name: parameter name has been deprecated and will
be removed from future releases.
Warning 1096 COMMAND .MODEL name: parameter name ignored.
Warning 1097 COMMAND .extract or .meas name contains symbols which are not handled
in extract-mode. This command is ignored.
Warning 1098 COMMAND .FOUR: name removed. Node name is unknown.
Warning 1099 COMMAND .FOUR: name removed. Device name is unknown.
Warning 1263 Ambiguity on parameter %s. Value used is %e. value defined by SST is %e
Warning 1400 EXTRACT MODE: File %s has been sampled at frequency %e Hz. Extracted
values might be inaccurate
Warning 1401 COMMAND .PRINTFILE: The command is ignored because file %s can not
be opened
Warning 1402 COMMAND .PLOT FOURMODSST: %s will represent the first harmonic of
the signal
Warning 1403 COMMAND .PLOT CONTOUR: unable to plot the contour. Extract %s can
not be used, it must define a vector of values (using VECT or CATVEC)
Warning 1404 COMMAND .PLOT CONTOUR: unable to plot the contour. The vectors of
values of CATVEC extracts don't have the same size
Warning 1405 COMMAND .AGE: parameter %s is assumed to be a user defined parameter
Warning 1406 OBJECT "%s": ambiguity found: using parameter %s instead of model %s
Warning 1407 OBJECT "%s": ambiguity found: using model %s instead of parameter %s
Warning 1408 OBJECT "%s": The following parameter(s) has(ve) multiple definitions : %s
Warning 1409 COMMAND .AGE: a non-numerical character was found in TAGE=%s
specification. It is ignored, thus if a unit was meant consider using TUNIT
keyword
Warning 1410 COMMAND .PROBE: %s is used as default analysis for command(s) not
specifying it
Warning 1411 EXTRACT MODE: wave %s can not be found in file %s. Maybe a .plot or
.probe command should be added in the original netlist before running the
eldo -extract command
Eldo® User's Manual, 15.3 1439