eldo_user

Error and Warning Messages
Miscellaneous Warnings
Warning
Number
Table A-16. Miscellaneous Warnings (cont.)
Description
Warning 945 Both the size of device %s and binned parameters of its model are affected by
MC variation. This situation cannot be handled. Use .option
"mc_ignore_binning" to ignore montecarlo variation on binning parameter
(lmin/lmax...)
Warning 946 Unable to evaluate GET_E(%s) on instance %s. That parameter has to be
defined either on the instance or in the model card of that instance
Warning 947 COMMAND "%s": previous values superseded
Warning 948 COMMAND .SAVE : Saving DC data requested but No DC analysis has
been actually performed
Warning 949 COMMAND "%s": Parameter %s ignored
Warning 950 COMMAND "%s": only top level parameters are elaborated in %s mode.
That may lead to errors during the parse of if-endif statements
Warning 951 COMMAND "%s": Saving time lower than HMIN. Set Eldo option 'HMIN'
to a lower value if needed
Warning 952 %d threads have been requested but Eldo detects only %d processors. Using
more threads than the number of processors of the computer might greatly
slow down the simulation
Warning 953 The number of requested threads (%d) is too high compared to the detected
number of processors. Eldo will use %d threads
Warning 954 Negative number of threads has been specified. Eldo will run in monothread
Warning 955 COMMAND .SETSOA: Error in the expression %s
Warning 959 COMMAND "%s": Unable to parse expression %s
Warning 962 OBJECT "%s": %s is negative, value is clipped to 0.0
Warning 963 COMMAND .NOISETRAN inside Premier parameter %s has been %s
Warning 1001 .NOISETRAN ignored: Only single TRAN analysis is allowed
Warning 1002 .NOISE ignored because the output node is not defined
Warning 1003 .SWITCH: Element name not found
Warning 1004 .MCMOD: Parameter name not known
Warning 1005 .MCMOD: Element name not known
Warning 1006 COMMAND name removed from the include file
Warning 1007 .SAVE and .RESTART used on the same file: .SAVE ignored
Warning 1008 COMMAND name found in include file
1434
Eldo® User's Manual, 15.3