eldo_user

Error and Warning Messages
Miscellaneous Warnings
Warning
Number
Warning 927
Warning 928
Warning 929
Warning 930
Warning 931
Warning 932
Warning 933
Warning 934
Warning 935
Warning 936
Warning 937
Warning 938
Warning 939
Warning 940
Warning 941
Warning 942
Warning 943
Warning 944
Table A-16. Miscellaneous Warnings (cont.)
Description
No IPROBE named %s found
.PARAMOPT %s : %s has already been defined using (xinit=%s, xmin=%s,
xmax=%s, xincr=%s)
.PARAMOPT %s : %s is now defined with (xinit=%s, xmin=%s, xmax=%s,
xincr=%s)
OBJECT "%s": TABLE not supported in NOISETRAN analysis. Table
values ignored
Command %s: %s expected. Command ignored
LOCATION_MAP File: %s doesn't exists or is not a file
Environment variable MGC_LOCATION_MAP = %s doesn't exists or is not
a file
Unable to find the mgc_location_map file. That may lead to errors during the
parse
If it is expected to accept Hierarchical characters in node name, it is still
possible to use .option dotnode
COMMAND .SNF: duplicate SNF found with label %s. The values of the
previous SNF will be overwritten by the current one. If this is not expected,
please change the label of one of these SNF
COMMAND .OPTION %s is ignored on %s side
In mgc_location_map, %s: No such directory. Soft name %s not loaded: Eldo
might not be able to load some libraries
Inductor/"voltage source" loop found. Voltage loop made of 0 voltage
sources only can be accepted using .OPTION LOOPV0. Voltage loop may
lead to singular matrix during simulation
Unable to find a model on device %s which satisfies binning conditions
(lmin, lmax, ...) and model name (current model name is %s)
Because it would give negative value, small-channel noise contribution
disabled on device %s
%s cannot be executed when design contains "%s" descriptions
The netlist contains both a .variation block and some montecarlo variation
specifications given on .param, device or model parameters. Only the
.variation block is used, the other variation specifications are ignored
Eldo® User's Manual, 15.3 1433