eldo_user

Error and Warning Messages
Warnings Related to Nodes
Warning
Number
Warning 85
Warning 86
Warning 87
Warning 88
Warning 89
Warning 90
Warning 91
Warning 92
Warning 93
Warning 100
Description
Table A-10. Global Warnings (cont.)
The characters 0 found at the beginning of node name which contains only
integer characters (such as in name) are removed. Use .option nodestr if this
should not be the case, i.e if those 0 should be considered as being actually part
of the node name.
Command line argument mthread / usethread has been removed. The
command line argument -use_proc is the only supported.
Some X or device instances connected in parallel have been merged into a
single instance. This may cause some unexpected warning or error messages.
See Eldo documentation for detail. To prevent this merging, please use .option
nocatmx .
Command name seen while COMPAT was already name. Ignored
No .ENDCOMPAT found in the design: section between .COMPAT and .END
is assumed to be in COMPAT mode.
name is not supported with name
Recursive file inclusion found: "name"
Multiple name not allowed in Questa ADMS in compat mode: only last name
values will be used
name has been deactivated due to name
This version of Eldo does not include name
Warnings Related to Nodes
The following warning messages are preceded by NODE :
Table A-11. Warnings Related to Nodes
Warning Description
Number
Warning 101 Significant node voltage variation, but of a lesser magnitude than VTH at time:
number
Warning 102 Number of iterations at time: number
Warning 103 Attempt to redefine .IC
Warning 104 Attempt to redefine .NODESET
Warning 105 Decreasing time on time-values associated to the .IC command
Warning 106 Global node already defined
Eldo® User's Manual, 15.3 1415