eldo_user

Error and Warning Messages
Global Warnings
Warning
Number
Warning 68
Warning 69
Warning 70
Warning 71
Warning 72
Warning 73
Warning 74
Warning 75
Warning 76
Warning 77
Warning 78
Warning 79
Warning 80
Warning 81
Warning 82
Warning 83
Warning 84
Description
Table A-10. Global Warnings (cont.)
Objects number mismatch while doing .restart: "name" objects to read while
"name" objects currently in memory. The object's states may not be fully
restored.
Objects mismatch while doing .restart:
reading object name "name" while expecting object "name". The object's
states may not be fully restored.
Command name appears in an if-endif section. This can lead to unexpected
behaviour. The if-endif sections should contain device instantiations only.
Unable to measure ISUB(name) in Whitebox Mode. Use blackbox instead.
Maximum number of messages reached. Subsequent messages will not be
displayed.
Maximum number of messages reached for message name. Subsequent
messages will not be displayed.
.option RGND used with Questa ADMS may not add, in some cases, a
grounded resistor on all HDL instance nodes
Z state not allowed when SST analysis is running. SST analysis disabled.
Default time specification used on device name, but .TRAN card appears later
in the design. Please, set .TRAN earlier to prevent any possible time
specification problem.
Voltage loop found, but accepted because containing only 0 voltage sources:
Unbalanced double quotes in line name. Strings defined in double quotes can
not be splitted into several lines. That can lead to an unexpected behavior.
Recursive inclusion of file name detected during name. Bypassing the last
inclusion and continuing the execution. For your information, the inclusion
stack is: name
The name name comes from name and is in name (accessed during .step lib
command). name will not be updated. However, if you want to force the update
of elements that doesn't come from the same libraries, use .option force_update
in the netlist.
The name name comes from name and is in name (accessed during .step lib
command). Updating of name forced. However, if you don't want to update
elements that doesn't come from the same libraries, remove .option
force_update from the netlist.
Option name found: no more warning displayed.
PORT related output name not supported on SSTAC.
Multithread required, but single processor machine. Option ignored.
1414
Eldo® User's Manual, 15.3