eldo_user

Error
Number
Description
Table A-1. Global Errors (cont.)
Error and Warning Messages
Global Errors
Error 15 The environment variable USER is not set by the system. Set this variable in your
.cshrc or .login script
Error 16 Unable to allocate number bytes. Memory already allocated name
Error 17 MEMALLOC: Unable to allocate number bytes. Memory already allocated name
Error 18 MAMALLOC: Unable to allocate number bytes. Memory already allocated name
Error 19 Unable to load file name. Analysis stopped
Error 20 The number of plots of the current simulation does not match the number of plots
of the previous one. File reading stopped
Error 21 Storage capacity exceeded. Memory already allocated name, eldo_mem_used()
Error 22 Circuit nesting error (please check that all .SUBCKT have a corresponding
.ENDS)
Error 23 Unrecognized character or word
Error 24 Unexpected end of file
Error 25 Line not consistent with language syntax
Error 26 No analysis specified
Error 27 Inductor/Voltage source loop foundTo allow a voltage loop made up of 0 voltage
sources use .OPTION LOOPV0 To downgrade this error to a warning use
.OPTION VOLTAGE_LOOP_SEVERITY = WARNINGVoltage loops may lead
to singular matrix during simulation
Error 28 Unable to reallocate name
Error 29 Trying to add a NULL element into the name. Please contact the office from
which you obtained this product with the message above and the circuit that
causes this error.
Error 30 Mismatch in model specification for device name
Error 31 DATA or SWEEP specification: : POI expects a positive number, name found
Error 32 Switch option cannot be used on device name
Error 33 Spectre file not specified
Error 34 .OPTIMIZE MOD: no parameter specified
Error 36 .OPTION LVLTIM must be 0, 1, 2, 3, or 4
Error 37 Memory allocation failure in name during name while trying to allocate: number
bytes
Error 38 Compilation errors in file name
Eldo® User's Manual, 15.3 1381