eldo_user

Eldo Netlist Setup
Device Libraries
op11A.ckt (not searched)
OP11A.ckt (searched first)
op11a.ckt (searched second)
OP11A.sub (searched third)
op11a.sub (searched fourth)
OP11A.cir (searched fifth)
op11a.cir (searched last)
Related Topics
Device Libraries
Tip
See “.ADDLIB” in the Eldo Reference Manual.
Using Libraries in Eldo Interactive Mode
It is possible to use the .LIB mechanism in Eldo interactive mode. The netlist must contain one
or several lines of type:
.LIB KEY=kname FNAME [LIBTYPE]
In interactive mode, the following commands can be issued:
.LIB key=toto mymod.tech nominal
.LIB key=toto mymod.tech worst
.LIB key=toto mymod2.tech
Eldo will search for the kname to identify which library must be replaced. Limitations of the
.LIB command when issued in interactive mode are as follows:
• Subcircuits are not replaced.
When .LIB is specified in the input file, it can be used to select a subcircuit to be
included in the design. Since taking a subcircuit from another library than the library
specified in the input file could result in a change of topology (and changing topology of
the current design is strictly impossible), Eldo would issue an error whenever the user
attempts to substitute one subcircuit for another.
• Switching between GUDM and non-GUDM models is prohibited. Similarly, switching
between GUDM models is prohibited.
• Only MOS, BJT, DIODE, JFET, R, L and C .MODEL commands can be substituted.
Attempting to substitute other kinds of models will lead to an error.
Tip
See “.LIB” in the Eldo Reference Manual.
Eldo® User's Manual, 15.3 137