Understanding API ICP653 Reading 15-Worksheet-11a
Charlie Chong/ Fion Zhang #1
TASK# 1 Read the following paragraphs then answer the questions. General Requirements QW-100 thru QW-195 Q1. The cut surfaces of guided-bend test specimens is designated as the: (a) sides. (b) face. (c) root. Q2. What is the angular deviation for groove weld tests from the specified inclined plane? (a) None/ (b) ±5° (c)±10° Charlie Chong/ Fion Zhang
- Page 1 and 2: Charlie Chong/ Fion Zhang
- Page 3 and 4: Expert at Works Charlie Chong/ Fion
- Page 5 and 6: Expert at Works Charlie Chong/ Fion
- Page 7 and 8: Charlie Chong/ Fion Zhang Fion Zhan
- Page 9 and 10: The Magical Book of Tank Inspection
- Page 11 and 12: API 653 Exam Administration -- Publ
- Page 13 and 14: • API Recommended Practice 575, I
- Page 15 and 16: Charlie Chong/ Fion Zhang
- Page 17: ASME SECTION IX EXERCISES Charlie C
- Page 21 and 22: Q5. Where are notch-toughness requi
- Page 23 and 24: Q9. How is the minimum specimen cur
- Page 25 and 26: Q13. Procedure and performance macr
- Page 27 and 28: Charlie Chong/ Fion Zhang #2
- Page 29 and 30: QW-191.1 Radiographic Examination Q
- Page 31 and 32: Q3. When may longitudinal-bend test
- Page 33 and 34: QW-100.3 Welding Procedure Specific
- Page 35 and 36: Q8. What are the test orientations
- Page 37 and 38: Task#2 Ref Para. 1. A QW-10()3 2. B
- Page 39 and 40: Reading: General Requirements QW-10
- Page 41 and 42: Q5. What constitutes a "set" of red
- Page 43 and 44: Q7. The WPS must list ___ variables
- Page 45 and 46: Task#3 Ref Para 1. A QW-484 2. C QW
- Page 47 and 48: Reading: Procedure Qualifications Q
- Page 49 and 50: Q5. The qualification of the ___is
- Page 51 and 52: QW-200.4 (b) For GTAW, SMAW, GMAW,
- Page 53 and 54: Charlie Chong/ Fion Zhang #5
- Page 55 and 56: QW-200.4 Combination of Welding Pro
- Page 57 and 58: Discussion: GTAW PQR variables: T=1
- Page 59 and 60: Q5. What limitation is invoked when
- Page 61 and 62: Q9: An organization's operational c
- Page 63 and 64: Q12. The ____ is a true record of t
- Page 65 and 66: Charlie Chong/ Fion Zhang #6
- Page 67 and 68: Reading: Performance Qualifications
TASK# 1<br />
Read the following paragraphs then answer the questions.<br />
General Requirements QW-100 thru QW-195<br />
Q1. The cut surfaces of guided-bend test specimens is designated as the:<br />
(a) sides.<br />
(b) face.<br />
(c) root.<br />
Q2. What is the angular deviation for groove weld tests from the specified<br />
inclined plane?<br />
(a) None/<br />
(b) ±5°<br />
(c)±10°<br />
Charlie Chong/ Fion Zhang