Deliverables and Services - IHP Microelectronics
Deliverables and Services - IHP Microelectronics
Deliverables and Services - IHP Microelectronics
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
68 A n n u A l R e p o R t 2 0 0 7<br />
A U S G E w ä H L T E P R O J E K T E – S E L E C T E d P R O J E C T S<br />
Abb. 36: Abhängigkeit der spektralen Lage der in EL beobachteten<br />
D1-Linie von der Fluss-Spannung (obere Achsenbeschriftung)<br />
und dem berechneten elektrischen Feld (untere<br />
Achsenbeschriftung) in einer LED bei 300 K. Die experimentellen<br />
Daten wurden mit der Beziehung<br />
für den quadratischen Stark-Effekt<br />
E ex =E ex (0)-αF 2 und den Werten: E ex (0)=795 meV ,<br />
α=0,0186 meV / (kV / cm) 2 angepasst (Linie).<br />
Fig. 36: the dependence of spectral position of el D1 peak on<br />
the value of forward bias (upper axis) <strong>and</strong> on the calculated<br />
maximal electric field (lower axis) in the leDs at<br />
300 K. experimental data are fitted with the<br />
equation for Stark effect: e ex =e ex (0)-αF 2 <strong>and</strong> the<br />
values: e ex (0)=795 meV, α = 0.0186 meV / (kV / cm) 2<br />
(solid line).<br />
Abb. 37: PL-Spektren einer LED bei 105 K aufgenommen mit<br />
identischem Niveau der optischen Anregung (P EXC = 50 mW)<br />
für verschiedene elektrische Anschlussbedingungen. Die<br />
Skizze in der Abbildung beschreibt schematisch die<br />
experimentellen Bedingungen. Die Kurven sind zur<br />
besseren Unterscheidbarkeit in vertikaler Richtung<br />
verschoben. Die Stromwerte, die während der PL-Untersuchungen<br />
an der Diode gemessen werden, sind angegeben.<br />
Für die oberste Kurve war die LED kurzgeschlossen<br />
und für die darunter liegende Kurve geöffnet.<br />
Fig. 37: pl spectra from the leD at 105 K detected at the same<br />
light-excitation level (p eXC = 50 mW) <strong>and</strong> various circuit<br />
conditions. A sketch in the figure shows the scheme of<br />
the experiment. Curves are shifted in vertical direction<br />
for clarity. the constant current through the diode<br />
during pl measurements is indicated in the graph above<br />
each curve. For the uppermost curve the leD contacts<br />
were shortened <strong>and</strong> for the curve beneath the contacts<br />
were open.