TUBING & PIPE
TUBING & PIPE - Alro Steel Corporation
TUBING & PIPE - Alro Steel Corporation
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
STRUCTURAL <strong>PIPE</strong> TOLERANCES<br />
Straightness<br />
1/8 times the number of feet of total length divided by 5<br />
Length Tolerance Mill Cut<br />
Up to 22 ft. 1/4 + 1/2<br />
Over 22 ft. to 44 ft. 1/4 + 3/4<br />
Outside Diameter (inches)<br />
0.840 thru 1.900 + 0.5%<br />
2.000 and larger + 0.75%<br />
The outside diameter measurements shall be made at positions at least 1"<br />
from either end of the pipe.<br />
TESTED <strong>PIPE</strong> (A-53) TOLERANCES<br />
Outside diameter at any point shall not very more than:<br />
Nominal Over Under<br />
1-1/2" and smaller 1/64" 1/32"<br />
2" and larger 1% 1%<br />
HYDRAULIC <strong>TUBING</strong> - (SEAMLESS)<br />
TOLERANCES<br />
SAE J-524<br />
The diameter of the tubing shall not vary from that specified more than the following<br />
amounts:<br />
OD Sizes<br />
Inches<br />
OD Diameter, In. Inside Diameter, In.<br />
Plus Minus Plus Minus<br />
Below 3-1/2 to 1-1/2 incl. 0.010 0.010 0.010 0.010<br />
Below 1-1/2 to 1/2 ID incl. 0.005 0.005 0.005 0.005<br />
Below 1/2 ID 0.003 0.003 0.005 0.005<br />
When the outside diameter and wall thickness of 1/2 inch to 3-1/2 inch OD tubes<br />
are specified, the outside diameter shall conform to the tolerances given in the<br />
above table, and the wall thicknesses shall not vary from that specified more than<br />
plus or minus 10 percent. When less than 1/2 inch ID, the outside diameter shall<br />
conform to the tolerances given in the above table. The wall thickness shall not<br />
vary from that specified more than plus or minus 15 percent.<br />
7-48<br />
alro.com<br />
Visit the Alro Web Site<br />
alro.com<br />
alro.com