Network UPS Tools User Manual
Network UPS Tools User Manual
Network UPS Tools User Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Network</strong> <strong>UPS</strong> <strong>Tools</strong> <strong>User</strong> <strong>Manual</strong> 52 / 84<br />
Name Description Example value<br />
ups.timer.reboot<br />
Time before the load will be rebooted 10<br />
(seconds)<br />
ups.timer.shutdown<br />
Time before the load will be shutdown 20<br />
(seconds)<br />
ups.test.interval Interval between self tests (seconds) 1209600 (two weeks)<br />
ups.test.result Results of last self test (opaque string) Bad battery pack<br />
ups.test.date Date of last self test (opaque string) 07/17/12<br />
ups.display.language Language to use on front panel (* E<br />
opaque)<br />
ups.contacts <strong>UPS</strong> external contact sensors (* F0<br />
opaque)<br />
ups.efficiency<br />
Efficiency of the <strong>UPS</strong> (ratio of the 95<br />
output current on the input current)<br />
(percent)<br />
ups.power<br />
Current value of apparent power 500<br />
(Volt-Amps)<br />
ups.power.nominal<br />
Nominal value of apparent power 500<br />
(Volt-Amps)<br />
ups.realpower Current value of real power (Watts) 300<br />
ups.realpower.nominal Nominal value of real power (Watts) 300<br />
ups.beeper.status<br />
<strong>UPS</strong> beeper status (enabled, disabled enabled<br />
or muted)<br />
ups.type <strong>UPS</strong> type (* opaque) offline<br />
ups.watchdog.status<br />
<strong>UPS</strong> watchdog status (enabled or disabled<br />
disabled)<br />
ups.start.auto <strong>UPS</strong> starts when mains is (re)applied yes<br />
ups.start.battery Allow to start <strong>UPS</strong> from battery yes<br />
ups.start.reboot<br />
<strong>UPS</strong> coldstarts from battery (enabled yes<br />
or disabled)<br />
ups.shutdown<br />
Enable or disable <strong>UPS</strong> shutdown<br />
ability (poweroff)<br />
enabled<br />
Note<br />
When present, the value of ups.start.auto has an impact on shutdown.* commands. For the sake of coherence, shutdown<br />
commands will set ups.start.auto to the right value before issuing the command. That is, shutdown.stayoff will first set<br />
ups.start.auto to no, while shutdown.return will set it to yes.<br />
C.1.3<br />
input: Incoming line/power information<br />
Name Description Example value<br />
input.voltage Input voltage 121.5<br />
input.voltage.maximum Maximum incoming voltage seen 130<br />
input.voltage.minimum Minimum incoming voltage seen 100<br />
input.voltage.nominal Nominal input voltage 120<br />
input.voltage.extended Extended input voltage range no<br />
input.transfer.delay<br />
Delay before transfer to mains 60<br />
(seconds)<br />
input.transfer.reason Reason for last transfer to battery (* T<br />
opaque)<br />
input.transfer.low Low voltage transfer point 91<br />
input.transfer.high High voltage transfer point 132<br />
input.transfer.low.min<br />
smallest settable low voltage transfer<br />
point<br />
85
Change language