Hohmann & Barnard catalog Reed First Source - Reed Construction ...

Section A - Masonry Systems
A16
Column and Beam Anchors
. #351
Wire Column
Tie
. #352
Wire Column
Tie
. #353
Column Anchor
. #353L
Column
Anchor
. #354
Notched Column
Anchor
. #355L
Column Anchor
. #357
Beam Anchor
#351 - 3”, 5”, 7” or 9” long. Other lengths available upon request.
For anchoring masonry to structural column when masonry is
parallel to column flange.
#352 - 8”, 10”, 12” or 14” long. Other lengths available upon request.
For anchoring masonry to structural column when masonry is
perpendicular to column flange.
Standard: 3/16” or 1/4” diameter with 2” Bend and 2-1/2”
Hook with 1/2” opening.
Finishes: Mill Galv, Hot Galv or Stainless Steel
H&B manufactures steel wire products from a minumun of
post industrial recycled material.
#353 Standard - 1-1/4” wide x 12ga. thick. Made to order
based on flange width and overall length. Other thicknesses
(including 1/4” heavy duty) available upon request.
For anchoring masonry to structural column when masonry is
perpendicular to column flange.
#353L Standard - Same as above. Made with a slotted hole
to accept Positive Lok Bolt to mechanically engage both sides
of the flange.
For anchoring masonry to the building frame while restraining
both positive and negative wind load actions.
#354 Standard - 1-1/2” wide x 12 ga. thick. Notch is 1” long,
beginning 1” from end. Made to order in any length. Other
notch sizes available on special order.
For anchoring masonry to structural column when masonry is
parallel to column flange.
#355L Standard - 1-1/4” wide x 12 ga. thick. Other thicnesses
(including 1/4” heavy duty) available upon request. Made
with a slotted hole to accept Positive Lok Rod.
For anchoring masonry to the building frame while restraining
both positive and negative wind load actions.
#357 Standard - 1-1/4” wide x 12 ga. thick. Other thicknesses
(including 1/4” heavy duty) available upon request. Made
to order in any length.
For anchoring masonry to structural beam when masonry is parallel
to column flange.
Finishes: Mill Galv, Hot Galv or Stainless Steel
Heavy duty plate for column & beam anchors is
post industrial recycled material.
Stainless Steel recycled content see page 22
For material conformances, submittal sheets, CAD drawings and MSDS sheets see WWW.H-B.COM
95 %
99 %
H& B recommends Type 304 Stainless Steel for maximum protection against corrosion.