The MOSEK command line tool Version 7.0 (Revision 141)

106 CHAPTER 9. PARAMETERS
9.1.38 MSK DPAR INTPNT TOL STEP SIZE
Corresponding constant:
MSK DPAR INTPNT TOL STEP SIZE
Description:
If the step size falls below the value of this parameter, then the interior-point optimizer assumes
that it is stalled. In other words the interior-point optimizer does not make any progress and
therefore it is better stop.
Possible Values:
Any number between 0.0 and 1.0.
Default value:
1.0e-6
9.1.39 MSK DPAR LOWER OBJ CUT
Corresponding constant:
MSK DPAR LOWER OBJ CUT
Description:
If either a primal or dual feasible solution is found proving that the optimal objective value
is outside, the interval [MSK DPAR LOWER OBJ CUT, MSK DPAR UPPER OBJ CUT], then MOSEK is
terminated.
Possible Values:
Any number between -inf and +inf.
Default value:
-1.0e30
See also:
• MSK DPAR LOWER OBJ CUT FINITE TRH Objective bound.
9.1.40 MSK DPAR LOWER OBJ CUT FINITE TRH
Corresponding constant:
MSK DPAR LOWER OBJ CUT FINITE TRH
Description:
If the lower objective cut is less than the value of this parameter value, then the lower objective
cut i.e. MSK DPAR LOWER OBJ CUT is treated as −∞.