Kennedy Hardware

Locks
Steel Half-Mortise Locks
Flush Mounted Steel Locks
Two way keyhole allows lock to be
mounted inside door or drawer. Bolt
throws left or right so that lock can
be used on left or right doors. Brass
plated steel.
L-20R Half-Mortise Lock
Rounded half-mortise lock for
drawers and right-hand doors. Steel.
Includes key. Lock is 1-3/4” wide x
1-9/16” deep. See illustration on
this page for dimensions.
L-40R Half-Mortise Lock
Rounded half-mortise lock for
drawers and right-hand doors.
Steel. Includes nickel-plated key.
Lock is 1-3/4” wide x 1-7/8”
deep.The distance from the center
of the pin to the top of lock is 7/8”.
L-1B 1” Wide x 1-3/4” High.
Includes brass plated key and a
brass keyhole cover.
L-20L Half-Mortise Lock
Rounded half-mortise lock for lefthand
doors. Same as L-20R except
for the position of the keyhole.
Use the illustration below for locks
L-20L and L-20R.
L-40L Half-Mortise Lock
Rounded half-mortise lock for lefthand
doors. Same as L-40R except
for the position of the keyhole.
L-3B 1-3/16” Wide x 2-5/8” High.
Includes two brass plated keys.
Note: Locks L-40R and L-40L are
deeper than L-20L and L-20R. The
overall height of the L-40 locks is
1-7/8” and the distance from the
center of the pin to the top of the
lock is 7/8”.
Full-Mortise Locks
Reproduction of full-mortise locks used in old American furniture.
Thickness 3/8”
S-15 Full-Mortise Lock
Lock can be used for drawers and
right-hand doors. Steel. Includes diecast
key. 1-7/16” High x 1” Wide. Pin
is centered 11/16” down from top of
lock.
S-15S Full-Mortise Lock
with Mounting Plate
Same as S-15 lock shown above
except that it includes a 2-1/8” x 3/8”
mounting plate.
39