my Latex and Tex4ht cheat sheet

\subsection{problem 3}
\lipsum[10]
\ifdefined\HCode
\TocAt{chapter,section} %turn on TOC
\PauseCutAt{section} % do not SPLIT this section
\fi
%------------------------------
\chapter{project}
\ifdefined\HCode
\else
{ %turn on local TOC
\startcontents[chapter]
\printcontents[chapter]{}{1}{\setcounter{tocdepth}{1}}
}
\fi
\section{introduction}
\lipsum[10]
\section{design}
\lipsum[10]
\section{appendix}
\lipsum[10]
\end{document}
3.4 Using mathjax with htlatex
htlatex can be made to use mathjax to render the math. These steps show how to that.
Will show two ways to do this. Is first is by telling tex4ht to generate mathml into the HTML page, then
load mathjax to render the mathml. The second way, is to tell tex4ht to just pass the latex code, as is, to the
HTML page, and let mathjax worry about the whole thing.
The second method above is better, since tex4ht has few issues with some of the mathml code for some math
symbols it generates. The current issue with this method though, is that there is no way to tell tex4ht to pass
the display math latex code to the HTML page. Only in-line latex code can be passed as is to the HTML page.
Hence, as of now, only the first method is really of practical use.
3.4.1 method one, tex4ht generates mathml
Assume the latex file is foo.tex
\documentclass{article}
\begin{document}
$\frac{a}{b}$
\end{document}
The file is compiled as
htlatex example1.tex "nma.cfg,htm,charset=utf-8" " -cunihtf -utf8"
where nma.cfg is
55