27.10.2015 Views

Advanced Configuration and Power Interface Specification

ACPI_6.0

ACPI_6.0

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>Advanced</strong> <strong>Configuration</strong> <strong>and</strong> <strong>Power</strong> <strong>Interface</strong> <strong>Specification</strong><br />

The platform enumerates the error source with event as the notification method using the format in<br />

Table 18-329 <strong>and</strong> Table 18-330<br />

The platform surfaces an error device, PNP ID PNP0C33, to the OSPM<br />

When the platform is ready to report an error, the platform populates the error status block including<br />

the block status field ( Table 18-330)<br />

Traditional ACPI platforms signal the error using an SCI, on the appropriate GPE:<br />

• The OSPM evaluates the GPE control method associated with this event as indicated on<br />

Section 5.6.4.1.1<br />

• OSPM responds to this notification by checking the error status block of all generic error<br />

sources with the SCI Generic notification type to identify the source reporting the error<br />

HW-reduced ACPI platforms signal the error using a GPIO interrupt on a pin designated as an ACPI<br />

event, as declared by the associated _AEI object:<br />

• The OSPM evaluates the control method associated with this event as indicated in<br />

Section 5.6.5.3<br />

• OSPM responds to this notification by checking the error status block of all generic error<br />

sources with the GPIO-Signal notification type to identify the source reporting the error.<br />

18.3.2.7 Hardware Error Notification<br />

This table describes the notification mechanism associated with a hardware error source.<br />

Table 18-332 Hardware Error Notification Structure<br />

Field<br />

Byte<br />

Length<br />

Byte<br />

Offset<br />

Description<br />

Type 1 0 Identifies the notification type:<br />

0 – Polled<br />

1 – External Interrupt<br />

2 – Local Interrupt<br />

3 – SCI<br />

4 – NMI<br />

5 - CMCI<br />

6 - MCE<br />

7 - GPIO-Signal<br />

All other values are reserved<br />

Length 1 1 Total length of the structure in bytes.<br />

<strong>Configuration</strong><br />

Write Enable<br />

2 2 This field indicates whether configuration parameters may be<br />

modified by OSPM. If the bit for the associated parameter is set,<br />

the parameter is writeable by OSPM:<br />

Bit [0]: Type<br />

Bit [1]: Poll Interval<br />

Bit [2]: Switch To Polling Threshold Value<br />

Bit [3]: Switch To Polling Threshold Window<br />

Bit [4]: Error Threshold Value<br />

Bit [5]: Error Threshold Window<br />

All other bits are reserved.<br />

728 April, 2015 Version 6.0

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!