POLYURETHANE
Sin tÃtulo-1 - Tecnopol
Sin tÃtulo-1 - Tecnopol
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Peripherals and auxiliary: It is important to evaluate and check the status of drains, walls, facades<br />
encounters, other next buildings, etc.. to proceed to completion before the application of<br />
waterproofing DESMOPOL membrane.<br />
Superficial cohesion: during the restoration of tiled roofs, removes all unattached tiles and replace<br />
them to keep a flat structure deck, you must also check that the grouting of the tiles is properly<br />
executed. If there are previous waterproofing systems should be checked for adherence and remove<br />
them in case of being in poor condition. Important: If applied to thin bricks are required placement of a<br />
geo-textile mesh to reinforce the waterproofing membrane.<br />
3 Primer use<br />
In most cases it is recommended to use a bi-component polyurethane primer as PRIMER-PU 1050 to<br />
give better adhesion and to prevent bubble formation.<br />
It should be applied by brush, roller or spray equipment (airless), and if necessary a light dusting with<br />
quartz sand from 0.3 to 0.8 mm to increase adhesion and mechanical fixation of the next system<br />
element.<br />
It is essential that the surfaces are in good condition, and fully cured for 28 days (DTU 21 and norm NF<br />
EN 206-1). It must have a low vapour transmission (less than 3 lb/24/h./1.000 ft / 2 test method<br />
RMA).<br />
7<br />
4 DESMOPOL membrane<br />
DESMOPOL can be applied with spray equipment or manually.<br />
In both cases the application must be done uniformly. Although it<br />
can be applied during a cold, wet weather, it is preferable that the<br />
temperature is between 5 ° C and 35 º C and relative humidity<br />
does not exceed 85%. In case of use of spray equipment, it must<br />
be capable of supplying pressure of 280 bar (4000 psi). In manual<br />
applications simply require the use of brush (brush), roller or<br />
squeegee.<br />
5<br />
Finishing layer (optional)<br />
Once the application of DESMOPOL membrane is made, and preferably before 76 hours from its<br />
application, it is advisable to spray one or two layers of aliphatic polyurethane top-coating membrane<br />
as TECNOTOP 1C, to obtain a perfect finishing and to ensure the stability of the desired colour.<br />
TECNOTOP 1C is also needed on surfaces that require resistance to traffic and to waterproof<br />
surfaces that require resistance to chemicals.<br />
LIQUID <strong>POLYURETHANE</strong> MEMBRANE