FlowCERT
Flow Cert Second Edition.pdf - Pulsar Process Measurement
Flow Cert Second Edition.pdf - Pulsar Process Measurement
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Parameter Set Value Description<br />
P213 / P214<br />
Relay 1<br />
ON/OFF<br />
depends on<br />
application<br />
Set required Alarm Setpoints.<br />
P223 / P224<br />
Relay 2<br />
ON/OFF<br />
P233 / P234<br />
Relay 3<br />
ON/OFF<br />
P243 / P244<br />
Relay 4<br />
ON/OFF<br />
P253 / P254<br />
Relay 5<br />
ON/OFF<br />
P708 Flow<br />
Decimal<br />
depends on<br />
application<br />
depends on<br />
application<br />
depends on<br />
application<br />
depends on<br />
application<br />
Set required Alarm Setpoints.<br />
Set required Alarm Setpoints.<br />
Set required Alarm Setpoints.<br />
Set required Alarm Setpoints.<br />
2 Set the number of decimal points required<br />
in the flow rate display<br />
P709 Flow<br />
Cut Off<br />
P830<br />
mA Out<br />
Range<br />
P870<br />
Fill Damping<br />
P871<br />
Empty<br />
Damping<br />
5.00% Enter as a percentage of maximum flow,<br />
the minimum flow rate to be added to the<br />
totaliser.<br />
2= 4 to 20<br />
mA<br />
What the mA output uses for the range.<br />
0= Off, 1= 0 to 20 mA, 2= 4 to 20 mA,<br />
3= 20 to 0 mA, 4= 20 to 4 mA.<br />
10 m/min Rate of maximum fill rate (set above the<br />
actual fill rate of the vessel).<br />
10 m/min Rate of maximum empty rate (set above<br />
the actual empty rate of the vessel).<br />
The default values used for determining the relay setpoints, when setting<br />
Alarm relays, via the Quick Setup menu are entered as a % of span and are<br />
as follows.<br />
Relay Function Alarm ID<br />
On Off<br />
Setpoint Setpoint<br />
Alarm Hi Hi 90% 85%<br />
Alarm High 85% 80%<br />
Alarm Low 10% 15%<br />
Alarm Lo Lo 5% 10%<br />
Page 51
Change language