FlowCERT

Hot Keys
There are five hot keys on the keypad, which can be used to quickly access
common parameters for viewing only, while in Run Mode. Pressing the hot
key once will display the first parameter, then repeated pressing will display
the others, then the FlowCERT reverts to Run Mode. In program mode,
they have different functions, the functions are shown below.
Hot
Key
Run Mode
When application is Flow, view
non-resettable totaliser. View
and reset the resettable totaliser.
When application is Pump, view
total pump running hours, and
individual pump running hours.
Displays echo confidence, echo
strength, height above loss limit
(H.A.L.L.), average noise, peak
noise or temperature.
When application is Pump, view
total number of pump starts and
individual pump starts.
Instantaneous mA output.
Program Mode
Not used with FlowCERT.
Not used with FlowCERT.
Reset parameter to default
setting.
Not used with FlowCERT.
Dependant on application
displays Distance, Level, Space,
Head, Flow, Volume or rate of
change of level.
Not used with FlowCERT.
Gives details of unit type,
software revision and serial
number.
Toggle relay setpoints
between FlowCERT’s
units of measure and % of
span.
Takes you to the last
parameter edited, when you
first enter program mode.
Enter decimal point
Page 36