FlowCERT

Watchdog
You can check how many times the unit has been switched on, and look at
the date and time of the last ten starts. This can be useful if there have been
power failures or if for any reason the FlowCERT restarts due to a fault
condition. The FlowCERT can be backed up from a battery which
automatically cuts in during power failure, battery backed up units will
continue uninterrupted operation and therefore will not register a loss of
mains power. If, however, the battery were to fail during a mains power
interruption, a start up would be recorded once power has been restored.
The following parameters can be accessed by directly entering the parameter
number. To do this, enter the program mode and then type in the
appropriate parameter number.
P940 Number of Starts
This parameter shows how many times the unit has been powered up.
P941-P960 Start Date & Time
Parameters P941 and P942 show the date and time that the unit was last
started. There are ten start dates & times recorded, which are parameters
P943-P960. The first on the list are the most recent, and the last ones are the
oldest. These are read only, and cannot be changed.
Page 141