FlowCERT
Flow Cert Second Edition.pdf - Pulsar Process Measurement
Flow Cert Second Edition.pdf - Pulsar Process Measurement
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
P125 High mA Trim<br />
This parameter allows you to “calibrate” the <strong>FlowCERT</strong> to the High mA<br />
Input from the device being used. If the expected high value, from the<br />
device connected to the mA Input, is not displayed, then you can trim it<br />
using this parameter.<br />
Relay Parameters<br />
All relay related parameters are prefixed with a 2**.<br />
The second digit of the three figure parameter number denotes the relay<br />
number as follows:<br />
21* parameters for Relay 1<br />
22* parameters for Relay 2<br />
23* parameters for Relay 3<br />
24* parameters for Relay 4<br />
25* parameters for Relay 5<br />
The third digit selects specific parameter for the setting of the relays, which<br />
can be selected individually and results in the following parameter numbers<br />
for each relay.<br />
Relay 1 210 to 218<br />
Relay 2 220 to 228<br />
Relay 3 230 to 238<br />
Relay 4 240 to 238<br />
Relay 5 250 to 238<br />
Page 93
Change language