Radio Telemetry System
Optional Radio Telemetry System - Pulsar Process Measurement
Optional Radio Telemetry System - Pulsar Process Measurement
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Radio</strong> <strong>Telemetry</strong><br />
<strong>System</strong><br />
Features<br />
• Can be used with Ultra 5<br />
or Sludge Finder<br />
controllers<br />
• Factory fit or retro-fit<br />
• 2.4GHz global wireless<br />
standard<br />
• IP67, NEMA 6<br />
• 3Km line-of-sight range<br />
• Transmitter powered by<br />
Pulsar controller,<br />
receiver 10-30VDC<br />
• RS485 Option<br />
• Visual signal strength<br />
indicator<br />
• Frequency Hopping for<br />
signal security<br />
• Unlimited pairs in same<br />
location<br />
• Compact, easily installed<br />
Wireless connectivity for convenient and robust<br />
monitoring and control at a distance<br />
Pulsar’s <strong>Radio</strong> <strong>Telemetry</strong> <strong>System</strong> is available either as a factory or retro-fit option,<br />
allowing industry-standard 2.4GHz communication between Ultra 5 or Sludge<br />
Finder 2 units and remote systems. Use throughout a site, with a maximum range of<br />
3Km with clear line-of-sight and further options for longer range use.<br />
As a factory-fitted ‘node’, Pulsar’s <strong>Radio</strong> <strong>Telemetry</strong><br />
<strong>System</strong> transmits the information from up to two 4-<br />
20mA output signals and two relays to a matched<br />
receiver unit. Shorter range, on-site ‘round the<br />
corner’ signalling is robust and reliable, while the<br />
signal can operate over an impressive 3Km if a good<br />
line-of-sight signal is available. For longer range<br />
transmissions an upgraded ‘Multihop’ system is<br />
available.<br />
The factory-fitted system is supplied pre-connected<br />
to the 4-20mA output(s) and two of the relay<br />
connections.<br />
In both cases, units are paired so an unlimited<br />
number of pairs can be used in the same location,<br />
and transmission security is assured by ‘frequency<br />
hopping’ and a visual signal strength indicator.<br />
TRANSMITTER INTEGRATED<br />
INTO SLUDGE FINDER 2<br />
CONTROLLER<br />
The receiver is a compact (80mm x 80mm x 60mm)<br />
enclosure which simply requires a 10-30VDC supply<br />
and has a simple terminal strip connector to replicate<br />
the signals from the Pulsar controller.<br />
A second system is available to allow retro-fitting of<br />
wireless communication to existing installations, and<br />
consists of a ‘bound’ pair of transceivers for easy<br />
installation. The transmitter in this case is in another<br />
small enclosure, not integrated into the Pulsar<br />
controller.<br />
COMPACT, ROBUST AND COST-<br />
EFFECTIVE RECEIVER UNIT
<strong>Radio</strong> <strong>Telemetry</strong> <strong>System</strong>:<br />
Technical Information<br />
Pulsar Process Measurement Limited operates a<br />
policy of constant development and improvement<br />
and reserves the right to amend technical details<br />
as necessary<br />
RADIO TELEMETRY SYSTEM<br />
<strong>Radio</strong> range:<br />
<strong>Radio</strong> transmit power:<br />
Up to 3.2Km (2 miles), line-of-sight (with standard antenna)<br />
18dBm conducted, ≤ 21dBm EIRP<br />
Compliance: FCC ID UE300DX80-2400. Complies with FCC Part 15, Subpart C, 15.247<br />
ETSI/EN: In accordance with EN300 328: V1.7.1 (2006-05)<br />
IC: 7044A-DX8024<br />
Spread Spectrum Technology:<br />
Link timeout:<br />
Power requirements:<br />
Weight:<br />
Case material:<br />
FHSS (Frequency Hopping Spread Spectrum)<br />
1 or 4 seconds<br />
+10 - 30VDC. Consumption less than 1.4W (60mA) @ 24VDC<br />
0.26Kg (0.57lbs)<br />
IP rating: IP67, NEMA 6<br />
Temperature range:<br />
Indicators<br />
Wiring access:<br />
Outputs:<br />
Polycarbonate housing and rotary dial cover<br />
-20 to +85ºC (-4 to +185ºF)<br />
Red/green power LED, red/yellow signal LED<br />
2 off 1/2 inch NPT<br />
2 x digital outputs, 2 x 4-20mA analogue outputs<br />
Pulsar ® Process<br />
Measurement Ltd.<br />
Cardinal Building<br />
Enigma Commercial Centre<br />
Sandy's Road<br />
Malvern<br />
Worcestershire<br />
WR14 1JJ<br />
England<br />
Tel: +44 (0) 1684 891 371<br />
Fax: +44 (0) 1684 575 985<br />
Email: info@pulsar-pm.com<br />
Pulsar ® Process<br />
Measurement Inc.<br />
P.O. Box 5177<br />
4565 Commercial Drive<br />
Suite 105<br />
Niceville<br />
FL 32578<br />
USA<br />
Tel: +1 850 279 4882<br />
Fax: + 1 850 279 4886<br />
Email: info.usa@pulsar-pm.com<br />
www.pulsar-pm.com<br />
Pulsar ® is a registered trademark of Pulsar Process Measurement Ltd in the UK and USA<br />
UK CERTIFICATIONS<br />
011 0 011<br />
ISO 9001:2008 ISO 14001:2004<br />
Registered Company<br />
Registered Company<br />
Cert No.950136-1 Cert No. 072570-1<br />
Lit No. TU R.<strong>Telemetry</strong> 2/13