Deltabar S PMD70/75 FMD76/77/78

www.aotewell.com www.fa-market.com info@aotewell.com
Deltabar S
Local operation
Remote operation
Function
External operation
(operating keys,
optional, not T17
housing)
Internal operation
(electronic insert)
Display (optional)
Position adjustment
X X X
(zero point correction)
Setting lower-range value
and upper-range value -
X
X
X
reference pressure present at
the device
(HART only)
(HART only)
Device reset X X X
Locking and unlocking
parameters relevant to the
- - - X
X
measured value
Value acceptance indicated
X X X
by green LED
Switching damping on and
- - - X
X
off
(HART and PA only)
Setting bus address (PA) - - - X X
Switching simulation mode
on and off (FOUNDATION
Fieldbus)
- - - X X
Depending on the position of the write protection switch on the device, all software parameters are accessible.
HART
Remote operation via:
• Handheld terminal Field Communicator 375 (see "Hardware and software for onsite and remote operation"
section ä 60)
• FieldCare (see "Hardware and software for onsite and remote operation" section ä 60 ff) with ommubox
FXA195 (see "Hardware and software for onsite and remote operation" section ä 60)
• Field Xpert:
Field Xpert is an industrial PDA with integrated 3.5" touchscreen from Endress+Hauser based on Windows
Mobile. It communicates via wireless with the optional VIATOR Bluetooth modem connected to a HART
device point-to-point or wireless via WiFi and Endress+Hauser’s Fieldgate FXA520. Field Xpert also works
as a stand-alone device for asset management applications. For details, refer to BA060S/04/EN.
PROFIBUS PA
Remote operation via:
• FieldCare (see "Hardware and software for onsite and remote operation" section ä 60 ff)
– Profiboard: For connecting a PC to PROFIBUS
– Proficard: For connecting a laptop to PROFIBUS
FOUNDATION Fieldbus
Remote operation via:
• Handheld terminal Field Communicator 375 (see "Hardware and software for onsite and remote operation"
section ä 60 ff)
• Use an FF-configuration program for example NI-FBUS Configurator, to
– connect devices with "FOUNDATION Fieldbus signal" into an FF-network
– set FF-specific parameters
Operation with NI-FBUS Configurator:
The NI-FBUS Configurator is an easy-to-use graphical environment for creating linkages, loops and a
schedule based on the fieldbus concept.
You can use the NI-FBUS Configurator to configure a fieldbus network as follows:
– Set block and device tags
– Set device addresses
– Create and edit function block control strategies (function block applications)
– Configure vendor-defined function and transducer blocks
– Create and edit schedules
– Read and write to function block control strategies (function block applications)
– Invoke Device Description (DD) methods
Endress+Hauser 59
AoteWell International.inc sales@aotewell.com Tel: +852-6563-2160