comdtinst m2400.1f - US Coast Guard Response Boat-Medium
comdtinst m2400.1f - US Coast Guard Response Boat-Medium
comdtinst m2400.1f - US Coast Guard Response Boat-Medium
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1.C. Classification.<br />
1. Unclassified. All circuits in this publication are<br />
unclassified, so that the radio frequency, circuit<br />
designators, and/or circuit titles may be coupled without<br />
affecting their classification.<br />
2. Classified. U.S. Navy circuits and/or frequencies that may<br />
be contained in OPLANS, may be classified and care should be<br />
taken in referring to them.<br />
D. Changes to COMDTINST M2400.1 (series).<br />
1. Discrepancies. Certain information contained in the annexes<br />
to COMDTINST M2400.1 (series) is subject to frequent change.<br />
It is the responsibility of any command concerned to report to<br />
the Commandant (G-TTM) errors or discrepancies found in this<br />
publication.<br />
2. Corrections. Corrections to COMDTINST M2400.1 (series) are<br />
made by formal changes. Interim changes will be promulgated<br />
by letter, message or electronic mail to those concerned and<br />
subsequently included in the next formal change or reprint of<br />
COMDTINST M2400.1 (series).<br />
E. Presentation. Unless otherwise indicated, information contained<br />
in this publication is presented as follows:<br />
1. kHz-MHz. Radio frequencies at or below 30 megahertz are<br />
expressed in kilohertz although normally the kHz symbol is not<br />
shown. Radio frequencies above 30.0 megahertz are shown with<br />
the MHz symbol.<br />
2. Carrier-Dial Frequency. Each radio frequency shown reflects<br />
the assigned or authorized frequency, which is the center<br />
frequency of the band occupied regardless of the type of<br />
emission employed. In the case of single sideband operation,<br />
the radio frequency shown in parenthesis after the assignment<br />
indicates the carrier or dial frequency.<br />
3. Emissions. The emissions shown indicate the authorized<br />
bandwidth for transmission on the radio frequency(ies) of the<br />
circuit. Where more than one emission is authorized, it is<br />
appropriately noted.<br />
4. UTC. All times are Universal Goordinated Time (UTC).<br />
1-2