268954910-Renault-Scenic.pdf

WHEELS AND TYRES
Tyres: Removal - Refitting
35A
a Finish fitting the tyre at the valve.
a Fit the exterior bead approximately 15 cm after the
valve using the tyre lever.
a Inflate the tyre to 3.5 bar to press the tyre beads
against the wheel rim.
III - FINAL OPERATION
a Refit the valve mechanism.
a Inflate the tyre to the recommended pressure (see
35A, Wheels and tyres, Tyre inflation pressure:
Identification, page 35A-10) .
Note:
It is not necessary to drive the vehicle before and
after a new wheel is balanced.
a Balance the wheel (see 35A, Wheels and tyres,
Wheel: Balancing, page 35A-4) .
a Refit the wheel in question (see 35A, Wheels and
tyres, Wheel: Removal - Refitting, page 35A-1) .
35A-9