268954910-Renault-Scenic.pdf

WHEELS AND TYRES
Tyres: Removal - Refitting
35A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the wheel in question (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) ,
- the balance weights,
- the valve mechanism.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a
TYRE PRESSURE SENS.
WARNING
To a void any damage to the sensor, make sure
the tyre bead never presses on the sensor.
18885
a Position the tyre lever approximately 15 cm from the
valve on the outside of the wheel rim in order to remove
the exterior bead from the tyre.
a Remove the exterior bead of the tyre, finishing at the
valve.
a Position the tyre lever approximately 15 cm from the
valve on the outside of the wheel rim in order to remove
the bead from inside the tyre.
a Remove the interior bead of the tyre, finishing at the
valve.
REFITTING
I - REFITTING PREPARATION OPERATION
WITHOUT TYRE PRESSURE SENS.
a parts always to be replaced: Tyre valve (13,05,
02,02)
a Detach:
- the bead from the outside of the tyre, starting with
the side opposite the valve,
- the bead from the inside of the tyre.
18884
a Lubricate the two tyre beads correctly using the
TYRE PASTE (see Vehicle: Parts and ingredients
for the repairwork) (04B, Consumables -
Products).
II - REFITTING OPERATION FOR PART
CONCERNED
a Engage the lower tyre bead approximately 15 cm after
the valve.
35A-8