268954910-Renault-Scenic.pdf

REAR AXLE COMPONENTS
Rear axle rubber bearing: Removal - Refitting
33A
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace:
- the rubber bushes,
- the nuts of the rear axle elastic bearings,
- the rear axle bolts.
II - REFITTING OPERATION FOR PART
CONCERNED
a Position the rubber bush so as to to align the notch
of the new rubber bush and the mark made previously
on the rear axle.
122815
a Tighten the tool rod (Tar. 1838) until the cover comes
into contact with the rear axle.
a Check that the notch is always aligned with the
mark.
a Torque tighten the nut of the cover B (16 Nm).
a Remove the (Tar. 1838).
a Refit the bearings.
a Torque tighten the new bolts of the rubber bearings
(130 Nm).
III - FINAL OPERATION.
122817
a Fit:
- the covers (A) and (B) of the tool (Tar. 1838),
- the threaded rod (C) of the tool (Tar. 1838),
- the washer (D) of the tool (Tar. 1838),
- the nut (E) of the tool (Tar. 1838).
a Refit:
-the rear axle (see 33A, Rear axle components,
Complete rear axle: Removal - Refitting, page
33A-21) ,
- the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
a Adjust the rear axle (see 30A, General information,
Rear axle: Adjusting, page 30A-20) .
33A-20