268954910-Renault-Scenic.pdf
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
REAR AXLE COMPONENTS<br />
Rear brake pads: Removal - Refitting<br />
33A<br />
Essential special tooling<br />
Fre. 1190-01<br />
Brake calliper piston return<br />
tool.<br />
Tightening torquesm<br />
calliper guide pin lower<br />
bolt<br />
36 N.m<br />
When replacing brake pads, be sure to replace the<br />
pads on the opposite side.<br />
WARNING<br />
To avoid damaging the parking brake cable protectors<br />
and causing premature wear of the system, do<br />
not handle the cables with a tool.<br />
REMOVAL<br />
I - REMOVAL PREPARATION OPERATION<br />
a Position the vehicle on a two-post lift (see Vehicle:<br />
Towing and lifting) (02A, Lifting equipment).<br />
a Rotate the calliper upwards.<br />
a Remove the brake pads.<br />
REFITTING<br />
101702<br />
a Release the parking brake.<br />
a Remove the rear wheels (see 35A, Wheels and tyres,<br />
Wheel: Removal - Refitting, page 35A-1) .<br />
II - OPERATION FOR REMOVAL OF PART<br />
CONCERNED<br />
a Unclip the parking brake cable.<br />
a Remove the calliper guide pin lower bolt (discard it).<br />
I - REFITTING PREPARATION OPERATION<br />
a Measure the thickness of the brake pads and compare<br />
them with the minimum values (see 30A, General<br />
information, Brake: Specifications, page<br />
30A-6) .<br />
a Clean using a wire brush and BRAKE CLEANER<br />
(see Vehicle: Parts and ingredients for the repairwork)<br />
(04B, Consumables - Products):<br />
- the calliper supports,<br />
- the callipers.<br />
a parts always to be replaced: Rear brake calliper<br />
guide pin bolt (13,03,04,10).<br />
33A-1