268954910-Renault-Scenic.pdf

FRONT AXLE COMPONENTS
Front axle sub-frame: Removal - Refitting
31A
EQT LEVEL SPORT
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the subframe equipment.
a Strap the sub-frame onto the component jack.
a Refit:
- the sub-frame,
- the bracket,
- the engine tie-bar .
a Tighten to torque:
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protection),
- the front wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) ,
- the universal joint.
a Torque tighten the universal joint bolt (24 Nm).
a Remove the safety strap(s) from the radiator.
a Adjust the axle assemblies (see 30A, General information,
Axle assemblies: Check, page 30A-8) .
- the subframe bracket bolts (62 Nm),
- the subframe tie-rod bolts (105 Nm),
- the engine tie-bar bolts on the engine (180 Nm),
- the engine tie-bar bolts on the subframe (105
Nm).
III - FINAL OPERATION.
a Refit:
- the pivots on their support,
- the subframe stiffener strut,
- the anti-roll bar tie bars,
- the ball joints.
a Tighten to torque:
- the pivot bolts (72 Nm),
- the subframe stiffener strut bolts (62 Nm),
- the anti-roll bar tie bar nuts (44 Nm).
- the track rod end nuts (37 Nm),
- the lower ball joint nuts (100 Nm).
a Connect the wheel speed sensor connector.
a Clip the wheel speed sensor wiring.
a Refit:
- the height sensor ball joint,
- the radiator cross member,
- the side panels.
a Tighten to torque:
- the radiator cross member front bolts (105 Nm),
- the radiator cross member rear nuts (21 Nm),
- the side panel bolts (21 Nm).
a Refit:
- the engine undertray,
31A-36