268954910-Renault-Scenic.pdf
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
FRONT AXLE COMPONENTS<br />
Front axle sub-frame: Removal - Refitting<br />
31A<br />
101209<br />
a Remove the sub-frame fittings.<br />
a Proceed in the reverse order to removal.<br />
REFITTING<br />
a Be sure to replace the sub-frame and arm mountings.<br />
a Degrease the surfaces on the body that make contact<br />
with the subframe and cross member using<br />
some SURFACE CLEANER.<br />
a Torque tighten and in order:<br />
- the sub-frame linkage bolt (105 Nm),<br />
- the rear cross member bolts on the subframe<br />
(62 Nm),<br />
- the bolts to the sub-frame tie-rod (105 Nm).<br />
WARNING<br />
Be sure to follow the sub-frame tightening order.<br />
a Torque tighten the lower arm bolts (see 31A, Front<br />
axle components, Front driveshaft lower arm:<br />
Removal - Refitting, page 31A-22) .<br />
WARNING<br />
A shim of 10 mm in thickness must be placed<br />
between the radiator cross member and the subframe.<br />
Centre the radiator cross member pin in<br />
the subframe hole at the level of the lower arm<br />
front mounting, to torque tighten the radiator<br />
cross member mountings.<br />
a Torque tighten:<br />
- the radiator cross member rear bolts (21 Nm),<br />
- the front mountings of the radiator cross member<br />
(105 Nm).<br />
- the lower ball joint bolts (60 Nm),<br />
- the engine tie-bar bolts on the subframe (105<br />
Nm),<br />
- the anti-roll bar tie rod ball joint nuts (44 Nm),<br />
- the track rod end nuts (37 Nm),<br />
- the side stiffener bolts (21 Nm).<br />
31A-29