268954910-Renault-Scenic.pdf

FRONT AXLE COMPONENTS
Front driveshaft hub carrier: Removal - Refitting
31A
101212
a Hang the « front brake calliper - front brake calliper
mounting » assembly on the suspension spring.
WARNING
In order to prevent irreversible damage to the
front hub bearing:
- Do not loosen or tighten the driveshaft nut when
the wheels are on the ground.
-Do not place the vehicle with its wheels on the
ground when the driveshaft has been loosened
or removed.
a Remove:
- the front brake disc bolts (5) ,
- the nut (6) from the front wheel driveshaft using the
(Rou. 604-01),
- the front brake disc,
a Position the (Sus. 1731).
a Tighten the bolt (8) of the (Sus. 1731) to remove the
hub carrier from the front driveshaft while holding it.
Note:
Take care not to drop the hub carrier.
a Check that section (9) of the (Sus. 1731) is pressed
firmly against the shock absorber base.
REFITTING
a Proceed in the reverse order to removal.
Note:
112078
The calliper mounting bolts must be coated with
a product such as HIGH RESISTANCE THREAD
LOCK before being refitted.
- the anti-roll bar tie rod upper nut (7) ,
- the anti-roll bar tie-rod.
a Extract the ball joints using the (Tav. 476).
a Remove the front wheel driveshaft from the front driveshaft
hub carrier, taking care not to extract the driveshaft
from the front wheel.
31A-13