268954910-Renault-Scenic.pdf
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
FRONT AXLE COMPONENTS<br />
Front brake calliper support: Removal - Refitting<br />
31A<br />
Fre. 1190-01<br />
calliper mounting bolts<br />
Essential special tooling<br />
Brake calliper piston return<br />
tool.<br />
Tightening torquesm<br />
10.5 daNm<br />
REFITTING<br />
a Push the piston back using the (Fre. 1190-01) until it<br />
is at the end of its housing.<br />
The calliper mounting bolts and the guide pin bolts<br />
must be coated with FRENBLOC type product before<br />
being fitted.<br />
a Refit:<br />
- the calliper mounting,<br />
guide pin bolts<br />
3.2 daNm<br />
- the calliper mounting bolts.<br />
a When replacing brake pads or a disc, it is essential<br />
to change the pads and disc on the opposite side.<br />
REMOVAL<br />
a Position the vehicle on a two-post lift (see Vehicle:<br />
Towing and lifting) (MR 370, 02A, Lifting equipment).<br />
a Remove the front wheels (see 35A, Wheels and tyres,<br />
Wheel: Removal - Refitting, page 35A-1) .<br />
a Torque tighten the calliper mounting bolts (10.5<br />
daNm).<br />
a Fit the pads, starting from the inside.<br />
a Refit:<br />
- the calliper,<br />
- the guide pin bolts.<br />
WARNING<br />
- Reattach the brake hose and wheel speed sensor<br />
wire if they have been detached.<br />
- Do not twist the brake hose.<br />
a Check the brake fluid level.<br />
a Torque tighten the guide pin bolts (3.2 daNm).<br />
a Refit the wheels (see 35A, Wheels and tyres,<br />
Wheel: Removal - Refitting, page 35A-1) .<br />
a<br />
IMPORTANT<br />
Depress the brake pedal several times to bring<br />
the pistons, brake pads and discs into contact.<br />
a Check the brake fluid level.<br />
a Remove the guide pin bolts (1) .<br />
101215<br />
a Hang the brake calliper from the suspension spring.<br />
a Remove:<br />
- the brake pads,<br />
- the two calliper mounting bolts (2) ,<br />
- the calliper mounting.<br />
a Check the condition of the braking components (replace<br />
defective parts).<br />
a Clean the calliper supports and callipers.<br />
31A-9