268954910-Renault-Scenic.pdf

FRONT AXLE COMPONENTS
Front brake calliper: Removal - Refitting
31A
Essential special tooling
Fre. 1190-01
Brake calliper piston return
tool.
Essential equipment
pedal press
Tightening torquesm
guide pin bolts
brake hose
bleed screw
wheel bolts
3.2 daNm
1.7 daNm
0.65 daNm
13 daNm
Note:
The callipers supplied as replacement parts are
pre-filled.
a When replacing brake pads or a disc, be sure to replace
the pads or disc on the opposite side.
REMOVAL
a Position the vehicle on a two-post lift.
WARNING
Prepare for brake fluid outflow, to prevent
damage to the mechanical parts and bodywork
around the braking system.
a Fit the pedal press to the brake pedal to limit the
outflow of brake fluid.
a Unlock the steering wheel.
a Remove the front wheels.
a Release the brake hose from the brake calliper.
a Remove:
- the two guide pin bolts (1) ,
- the brake calliper,
- the brake pads.
a Check the condition of the braking components (replace
defective parts).
a Clean the calliper supports and callipers.
REFITTING
a Push the piston back using the (Fre. 1190-01) until it
is at the end of its bore.
a Fit the pads, starting from the inside.
a Refit:
- the calliper,
- the guide pin bolt.
101214
a Torque tighten:
- the guide pin bolts (3.2 daNm),
- the brake hose (1.7 daNm).
WARNING
- Refasten the brake hose and wheel speed sensor
wiring, if they have been unclipped.
- Do not twist the brake hose.
31A-5