268954910-Renault-Scenic.pdf
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MECHANICAL COMPONENT CONTROLS<br />
Clutch circuit: Bleeding<br />
37A<br />
JH3 or JR5 or ND0 or PK4 or TL4<br />
Bleed screw with two clips.<br />
a Connect the brake circuit bleeding device (after<br />
having received <strong>Renault</strong> approval) to the master cylinder<br />
reservoir (see the instructions for the equipment).<br />
a Remove the bleed plug from the clutch slave cylinder.<br />
a Connect a transparent pipe to the bleed hole running<br />
to an empty container placed under the bleed hole.<br />
a Open the bleed screw.<br />
a Open the circuit between the bleeding device and<br />
the brake fluid reservoir.<br />
a Let the brake fluid run until all air bubbles have been<br />
released.<br />
a Stop the bleeding device to dump the pressure in the<br />
clutch circuit.<br />
a Close the bleed screw.<br />
a To open the bleed screw, lower the clip (6) and lift<br />
the clip (7) while pulling by one notch.<br />
III - BLEED PROCEDURE IF NO PARTS OF THE<br />
HYDRAULIC CIRCUIT ARE REMOVED<br />
113732<br />
1 - Bleed using the ARC50.<br />
a Keep the clutch pedal in the upper position using a<br />
strap attached to the steering wheel to ensure continuity<br />
of the hydraulic circuit during the bleed operation.<br />
a Remove the transparent pipe from the bleed hole.<br />
a Refit the bleed plug.<br />
a Top up the brake fluid level in the master cylinder reservoir<br />
after disconnecting the bleed device.<br />
a Disengage and engage the clutch quickly around<br />
twenty times.<br />
a Check that the clutch system is operating correctly.<br />
a Repeat the bleed operation if necessary.<br />
a Check the adjustment of the switch. (see 37A, Mechanical<br />
component controls, Clutch pedal<br />
switch: Removal - Refitting, page 37A-51) (37A,<br />
mechanical control elements).<br />
Note:<br />
Tak e care not to disrupt the adjustment of the<br />
clutch start of travel switch.<br />
37A-75