268954910-Renault-Scenic.pdf

MECHANICAL COMPONENT CONTROLS
Clutch pedal: Removal - Refitting
37A
RIGHT-HAND DRIVE
In the passenger compartment
REFITTING
a Check the condition of the seals.
a To refit, proceed in the reverse order of removal.
a Torque tighten the clutch pedal plate nuts (2.1
daNm).
a It is essential that the sensors are pulled to the end
stop to position them at the minimum.
The clutch pedal position sensors have an automatic
adjustment function which adjusts in accordance
with the position of the pedal.
101741
a Remove the grey start of travel switch (6) by turning
it a quarter of a turn.
a Disconnect the connector from the switch (6) .
a Remove the green end of travel switch (7) by turning
it a quarter of a turn.
a Disconnect the connector from the switch (7) .
a Place a cloth under the master cylinder.
a Remove the union clips on the master cylinder (8) .
a Disconnect the pipes.
a Fit plugs into the openings.
a Remove the clutch master cylinder ball joint from the
pedal.
a Disconnect the clutch pedal position sensor connector.
a Remove the clutch pedal position sensor.
a Remove the four clutch plate nuts.
a Extract the « pedal - master cylinder » assembly.
a Remove the master cylinder from the pedal assembly
by turning it clockwise a quarter of a turn (bayonet
type mounting).
102205
a Position the switches in their housing.
a Turn them one quarter turn clockwise.
a Reconnect the two clutch pedal switches.
a Bleed the clutch control (see 37A, Mechanical
component controls, Clutch circuit: Bleeding,
page 37A-73) .
WARNING
Connect the battery. carry out the necessary programming
(see (see 8, Electrical equipment) ).
37A-63