268954910-Renault-Scenic.pdf

MECHANICAL COMPONENT CONTROLS
Clutch pedal: Removal - Refitting
37A
LEFT-HAND DRIVE
Tightening torquesm
clutch pedal plate nuts
2.1 daNm
REMOVAL
a Disconnect the battery, starting with the negative
terminal.
a Remove the grey start of travel switch (2) by turning
it a quarter of a turn.
a Disconnect the connector from the switch (2) .
101899
a Remove the green end of travel switch (3) by turning
it a quarter of a turn.
104102
a Remove:
- the lower left-hand cover (see (see 5, Mechanisms
and accessories) ),
- the air duct (1) .
a Disconnect the connector from the switch (3) .
a Remove the clutch master cylinder ball joint from the
pedal (4) .
a Disconnect the clutch pedal position sensor connector.
a Remove the clutch pedal position sensor.
a Remove the three clutch pedal nuts (5) .
a Withdraw the clutch pedal assembly.
REFITTING
a To refit, proceed in the reverse order of removal.
a Torque tighten the clutch pedal plate nuts (2.1
daNm).
a It is essential that the sensors are pulled to the end
stop to position them at the minimum.
The clutch pedal position sensors have an automatic
adjustment function which adjusts in accordance
with the position of the pedal.
37A-59