268954910-Renault-Scenic.pdf

MECHANICAL COMPONENT CONTROLS
Gear control unit: Removal - Refitting
37A
AJ0
105108
104733
a Disconnect the automatic gearbox control unit connector
(8) .
a Remove:
- the automatic gearbox control unit nuts (9) .
- the bulkhead seal bolts.
Note:
Do not open the automatic gearbox control unit, it
could cause damage (infrared system).
a Remove the "unit - automatic gearbox control cable"
assembly through the passenger compartment.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the « unit - automatic gearbox control cable » assembly,
- the bulkhead seal bolts.
a Torque tighten the automatic gearbox control unit
nuts (21 Nm).
a Connect the automatic gearbox control unit connector.
a Clip the control cable on the gearbox at the sleeve
stop level.
104736
a Compress the spring of the automatic gearbox control
cable at (10) .
a Unlock the adjustment mechanism by pressing on
the catch (11) .
a Adjust the length of the automatic gearbox control
cable.
a Clip the automatic gearbox control cable anchoring
ball joint on the automatic gearbox.
a Lock the adjustment mechanism while pushing back
the catch to its initial position.
37A-57