268954910-Renault-Scenic.pdf

MECHANICAL COMPONENT CONTROLS
Clutch pedal switch: Removal - Refitting
37A
5 SPEED MANUAL GBOX or 6 SPEED MANUAL GBOX
REFITTING
II - REFITTING THE CLUTCH PEDAL SWITCHES
I - WHEN REMOVING AND REFITTING OR WHEN
REPLACING A CLUTCH PEDAL SWITCH
CRUISE CONTROL
a Depress the clutch pedal by hand.
a Position the start of travel switch on the pedal assembly.
a Lock the start of travel switch by turning it one quarter
of a turn clockwise.
a Support the return of the clutch pedal.
a
108434
Note:
The clutch pedal switch has an automatic adjustment
feature, adapting to the pedal position.
The automatic adjustment makes a clicking noise
when in operation.
WARNING
Handle the switch (3) with care.
Only operate the piston (4) to adjust the dimension
(X) .
The switch must be replaced:
- if the piston (4) is separated from the switch (3)
,
-if more than three adjustments to the dimension
(X) are necessary during the operation.
a Measure dimension (X) of the piston (4) . If the dimension
(X) is less than 17 mm, carefully pull on the
end of the piston (4) to adjust the dimension (X)
between the values 17 mm minimum and 18 mm
maximum.
a Connect clutch switch connector.
DOOR OPEN SYST. 433 NML
a Position the end of travel switch on the pedal assembly.
a Lock the end of travel switch by turning it one quarter
of a turn clockwise.
a Depress the clutch pedal by hand.
Note:
The clutch pedal switch has an automatic adjustment
feature, adapting to the pedal position.
The automatic adjustment makes a clicking noise
when in operation.
a Support the return of the clutch pedal.
a Connect clutch switch connector.
III - FINAL OPERATION
a Be sure to carry out a repair check using diagnostic
tool.
37A-53