268954910-Renault-Scenic.pdf
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MECHANICAL COMPONENT CONTROLS<br />
Clutch master cylinder: Removal - Refitting<br />
37A<br />
JH3 or JR5 or ND0 or PK4, and RIGHT-HAND DRIVE<br />
PK4<br />
101741<br />
115170<br />
a Remove:<br />
- the engine undertray,<br />
- the bleed plug (6) .<br />
a Turn the end (7) of the slave cylinder anticlockwise<br />
as far as it will go.<br />
a Connect a transparent pipe to the bleed hole running<br />
to an empty container placed under the bleed hole.<br />
a Place a cloth under the bleed hole.<br />
a Depress the pedal using your hand (to drain the<br />
master cylinder and the pipe).<br />
a<br />
Note:<br />
The clutch master cylinder is mounted on the<br />
clutch pedal assembly. Remove the « pedal -<br />
master cylinder » assembly to remove the pedal<br />
and master cylinder.<br />
a Remove the grey start of travel switch (8) by turning<br />
it a quarter of a turn (see 37A, Mechanical component<br />
controls, Clutch pedal position sensor: Removal<br />
- Refitting, page 37A-64) .<br />
a Disconnect the switch connector (8) .<br />
a Remove the green end of travel switch (9) by turning<br />
it a quarter of a turn (see 37A, Mechanical component<br />
controls, Brake pedal switch: Removal - Refitting,<br />
page 37A-31) .<br />
a Disconnect the switch connector (9) .<br />
a Place a cloth under the master cylinder.<br />
a Remove the union clips from the master cylinder<br />
(10) .<br />
a Disconnect the pipes.<br />
a Fit plugs into the openings.<br />
a Remove the clutch master cylinder ball joint from the<br />
pedal.<br />
a Remove the four nuts from the « pedal » assembly.<br />
a Extract the « pedal - master cylinder » assembly.<br />
a Remove the master cylinder from the bulkhead by<br />
turning it a quarter turn clockwise (bayonet type<br />
mounting) using the (Emb. 1797).<br />
REFITTING<br />
a Visually check the condition of the seals.<br />
37A-45