268954910-Renault-Scenic.pdf
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MECHANICAL COMPONENT CONTROLS<br />
Parking brake cables: Removal - Refitting<br />
37A<br />
STANDARD CHASSIS, and AUTOMATIC PARKING BRAKE<br />
diagnostic tool<br />
Essential equipment<br />
This procedure only deals with removing - refitting the<br />
secondary brake cables.<br />
The primary brake cable cannot be removed. It is sold<br />
complete with the automatic parking brake control unit<br />
(see 37B, Electronic parking brake, Control unit:<br />
Removal - Refitting, page 37B-3) .<br />
REMOVAL<br />
I - REMOVAL PREPARATION OPERATION<br />
a Position the vehicle on a two-post lift (see Vehicle:<br />
Towing and lifting) (02A, Lifting equipment).<br />
a Switch on the + after ignition feed.<br />
a Release the parking brake using the handle.<br />
a Switch off the ignition.<br />
a Disconnect the battery (see Battery : Removal -<br />
Refitting) (80A, Battery).<br />
a Unclip the anchorage guard.<br />
104407<br />
II - OPERATION FOR REMOVAL OF PART<br />
CONCERNED<br />
104406<br />
a Remove the primary cable (2) from the anchorage.<br />
a Remove the secondary cables (3) from the anchorage.<br />
REFITTING<br />
I - REFITTING OPERATION FOR PART<br />
CONCERNED<br />
a Refit the secondary cables to the anchorage.<br />
a Note the brake cable routing for refitting.<br />
104403<br />
a Remove the bolts (1) from the brake cable anchorage<br />
support.<br />
a Clip on the secondary cables.<br />
a Refit the primary cable to the anchorage<br />
a Clip on the anchorage guard.<br />
a Refit the anchorage on the rear axle.<br />
37A-35