268954910-Renault-Scenic.pdf

MECHANICAL COMPONENT CONTROLS
Brake pedal bell crank rod: Removal - Refitting
37A
RIGHT-HAND DRIVE
When the brake pedal is replaced, the pedal is supplied
fitted with a pin.
REMOVAL
a Remove the brake pedal (see 37A, Mechanical
component controls, Brake pedal: Removal - Refitting,
page 37A-19) .
a Turn the brake pedal sensor (1) a quarter of a turn
anti-clockwise.
a Remove:
- the brake pedal sensor (1) ,
- the two nuts (4) from the idler bar retaining ring,
- idler bar securing ring,
-the shaft (3) connecting the « brake servo pushrod
and idler bar » assembly.
- the circlips at the ends of the idler bar.
103828
WARNING
Do not damage the clutch master cylinder pipes.
a Remove the idler bar through the passenger side of
the vehicle.
REFITTING
a To refit, proceed in the reverse order of removal.
a If replacing the pedal, (see 37A, Mechanical component
controls, Brake pedal: Removal - Refitting,
page 37A-19) .
a Adjust the brake pedal position switch (see 37A, Mechanical
component controls, Brake pedal
switch: Removal - Refitting, page 37A-31) .
37A-30