268954910-Renault-Scenic.pdf

MECHANICAL COMPONENT CONTROLS
Brake pedal: Removal - Refitting
37A
RIGHT-HAND DRIVE
Essential special tooling
Fre. 1752
Safety pin
Essential equipment
diagnostic tool
Tightening torquesm
brake pedal yoke mounting
nuts
21 Nm
IMPORTANT
- Before carrying out any work on a safety system
component, lock the airbag computer using diagnostic
tool (see 88C, Airbags and pretensioners,
Airbag computer locking procedure).
- When this function is activated, all the trigger lines
are inhibited and the airbag warning light on the
instrument panel is continuously lit (with the ignition
on).
- Handling pyrotechnic systems (airbags or pretensioners)
near to a source of heat or flame is forbidden:
there is a risk of triggering the airbags or
pretensioners.
104757
a Disconnect the connector from the accelerator pedal
position potentiometer.
a Remove:
- the mounting bolts (1) from the accelerator pedal,
- the accelerator pedal.
WARNING
When the brake pedal is replaced, the pedal is supplied
fitted with a pin. (Fre. 1752).
When removing and refitting (without replacing the
brake pedal), always fit the pin (Fre. 1752) during
removal.
REMOVAL
a Disconnect the battery, starting with the negative
terminal.
a Remove:
- the dashboard (see 83A, Instrument Panel, Dashboard),
- the steering column (see 36B, Power-assisted
steering, Steering column),
- the dashboard cross member (see MR 371 Bodywork,
42A, Upper front structure, Dashboard
cross member).
37A-26