268954910-Renault-Scenic.pdf
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MECHANICAL COMPONENT CONTROLS<br />
Brake servo: Removal - Refitting<br />
37A<br />
F4R or F9Q or K4J or K4M or K9K or M9R<br />
REFITTING<br />
a Bleed the brake circuit (see 30A, General information,<br />
Brake circuit Bleeding, page 30A-2) .<br />
a Connect the battery (see Battery : Removal - Refitting)<br />
(MR 370, 80A, Battery).<br />
a Adjust the brake pedal position switch (see 37A, Mechanical<br />
component controls, Brake pedal<br />
switch: Removal - Refitting, page 37A-31) .<br />
91101<br />
a Check the following dimensions before refitting:<br />
- for left-hand drive vehicles: (X1) = 163.7 mm,<br />
- for right-hand drive vehicles: (X1) = 133.2 mm.<br />
a Proceed in the reverse order to removal.<br />
IMPORTANT<br />
Check that the connecting shaft between the<br />
brake servo pushrod and the brake pedal is locked<br />
in place.<br />
a Torque tighten:<br />
- the servo mounting nuts (21 Nm),<br />
- the brake servo mounting bolts (21 Nm),<br />
- the gear lever sheath mounting bolts (21 Nm).<br />
a Refit:<br />
- the master cylinder (see 37A, Mechanical component<br />
controls, Master cylinder: Removal - Refitting,<br />
page 37A-1) ,<br />
-the air filter unit and the injection computer (see Air<br />
filter unit: Removal - Refitting) (MR 370, 12A,<br />
Fuel mixture),<br />
-the battery (see 80A, Battery, Battery: Removal -<br />
Refitting),<br />
- the scuttle panel grille (see Scuttle panel grille:<br />
Removal - Refitting) (MR 371, 56A, Exterior equipment),<br />
- the engine cover.<br />
37A-8